Klark Teknik DN9344E User Manual download pdf (Page 63)

HELIX DN9340E/DN9344E Remote Control Software

User Guide

63 of 65

8 Highlight your device in the

device list and double-click to

access the Device Details,

Web Configuration and Telnet

Configuration tabs.

9 Switch to the Web Configuration

tab and click Go to connect to

the UDS1100’s web

configuration pages (shown

below).

10 Under the Channel 1 heading on the left-

hand side of screen, click on Serial Settings

to access the Serial Settings screen.

11 Make the following settings in the Port

Settings section:

Protocol: as required (with Solo

Tracking you must use the

front panel RS-232 input

for the converter)

Baud Rate: “38400”

Data bits: “8”

Parity: “None”

Stop bits: “2”

Flow control: “None”

Click OK. (Done! will appear next to OK

to showthat settings have been stored.)

Important!

Remember to change the Serial Protocol if you

change from RS-232 to RS-485 input or vice

versa.

1 2 ... 58 59 60 61 62 63 64 65

Comments to this Manuals

No comments