Klark Teknik DN9344E User Manual download pdf (Page 46)

HELIX DN9340E/DN9344E Remote Control Software

User Guide

46 of 65

7.7 Solo Tracking Operation

If required, the Solo Tracking system of the Midas mixing console in use can be set up to select the

slave equalisers in the Helix Network. To enable this, the various Solo Tracking buttons must be

assigned to Helix channels via the System Solo Tracking Setup screen (shown below) and the settings

downloaded to a DN9340 Helix unit that is currently connected to the console Solo Tracking output (the

DN9344 does not have a Solo Tracking input).

 To open the System Solo Tracking Setup screen

 Switch to the FastNav

screen and choose Solo Tracking.

The screen contains a scrollable list similar to the Solo Tracking System Configuration page of the

DN9340E Helix unit, showing the 32 HELIX equaliser channels and their currently assigned solos.

Assignments are made via the fields in the Solo Tracking Setup panel at the right-hand side. The

available Solo Source and Num settings change to match the chosen Console Type.

 To assign solo sources to HELIX channels

1 Specify the console to be used for the performance in the Console

Type field in the top right-hand corner of the screen. Any

current assignments that are not valid for the chosen console

are flagged as invalid by an asterisk in the right-hand column.

2 Highlight the HELIX channel in the list and choose the required

Solo Source from the drop down list on the right-hand panel and

then choose a number from the Num drop down list. (The Num

list changes to suit the selected Solo Source).

This field defaults to the

Master Unit set in the

Function Lockout screen

List of console

Solos buttons

assigned to the

EQ channels

Name changes

will be copied

to Device

screens

Solo selections

change to match

Console Type

Clear all the

current

assignments

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 64 65

No comments

Klark Teknik DN9344E User Manual Page 46