Klark Teknik DN9344E User Manual download pdf (Page 18)

HELIX DN9340E/DN9344E Remote Control Software

User Guide

18 of 65

5.3 Dynamic Equalisation

 To switch to the Dynamic Equalisation view

 Click on the Dynamic button of the Channel A or B Navigation Strip, as required. (If staying

on the same Channel you may prefer to click on a Dynamic tab).

The upper Dynamic Mode tab is used to set the characteristic of the Threshold Dependent Dynamic EQ

( T-DEQ), bypass state and graph display mode (when a DN9340) for the current channel. The lower

Dynamic Shaping tab provides a control panel for each of the two Dynamic EQ sections that can be

applied to the frequency response. The Dynamic EQ sections can also be adjusted at the display by

using the target cursor.

 To set the Dynamic EQ mode for the channel

1 Select a Proportional, Constant or Symmetrical Q

characteristic from the EQ Type drop down

menu.

2 Use the Unit Display  drop down menu to set the

Dynamic EQ display mode that DN9340 units

should assume when taken out of slave

operation; this only comes into effect if the slave

is a DN9430. The choice made here has no

effect on your AddIn device display.

Note

Refer to the DN9340/DN9344 Operators Manual for application notes on Equalisation modes

and Q.

The black graph

shows overall

response. The

red graph shows

the response o

the selected LO

or HI Dynamic

The Dynamic

section’s freq,

level and Q are

adjusted by

dragging the

‘

target’ or

setting values

Dynamic Mode

tab

For a shelf

dynamic, choose

an E

slo

Tick the check box to switch the

PEQ section out of the circuit

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 64 65

Comments to this Manuals

No comments

Klark Teknik DN9344E User Manual Page 18

Comments to this Manuals