Klark Teknik DN9344E User Manual download pdf (Page 64)

HELIX DN9340E/DN9344E Remote Control Software

User Guide

64 of 65

12 Click Apply Settings to apply the changes;

you will see the “Please wait …”

message while the unit saves the

changes and reboots.

13 Close the Device Installer by selecting

File > Exit or by clicking on

in the top

right-hand corner of the window.

9.3.2 Connecting the system equipment

For an overview of the connections, please refer to the HELIX Remote Control Software: Brief Guide to

Setting Up an Ethernet System user guide.

 To connect up a HELIX RCS Ethernet System:

1 Connect, power up and set up the addresses of your slave HELIX units in a daisy chain

network as described in the DN9340 Operators Manual. If using Solo Tracking, the ‘first’

HELIX in the daisy chain must be located in the FOH Stack for connection to the console.

2 Connect the UDS1100 Converter to the first

HELIX, as follows:

For RS-232 communications (for example,

when using Solo Tracking), use a male D25

to male D9 cable joined to the host cable

(female D9 to 9-way mini DIN) to connect the

serial port of the Lantronix UDS1100

Converter to the PC port on the front panel of

the first HELIX unit in the daisy chain.

For RS-485 communications, use a male D25

to XLR cable to connect the UDS1100

Converter to the Comm In XLR plug on the

rear panel of the first HELIX unit in the daisy chain.

Important! Ensure that the Serial Protocol is set correspondingly to RS-232 or RS-485 in

the Lantronix Configuration web page. To view the page, enter the IP address of the

UDS1100 box into the web browser address field.

Activity

LEDs

RJ-45

port

Power

socket

Serial port

1 2 ... 59 60 61 62 63 64 65

No comments

Klark Teknik DN9344E User Manual Page 64