Klark Teknik DN9344E User Manual download pdf (Page 20)

HELIX DN9340E/DN9344E Remote Control Software

User Guide

20 of 65

 To switch a Dynamic section out of the circuit

1 Tick the  Out check box at the bottom

right-hand corner of its Dynamic control

panel.

The Dynamic is faded to grey on the graph and

its contribution is removed from the overall

frequency response. The target remains active

so that it can still be adjusted while switched

out.

2 To switch it in again, clear the check box.

5.4 Filters

 To switch to the Filter view

 Click on the Filter button of the Channel A or B Navigation Strip, as required. (If staying on

the same Channel, you may prefer to click on a Filter tab).

The upper Filter Mode tab is used to set the bypass state and the Graph display mode (when a DN9340)

for the current channel. The lower Filter Shaping tab provides a control panel for each added Filter.

Filter settings can also be adjusted at the display by using the target cursor.

Dynamic

switched out

The black graph

shows overall

response. The

red graph shows

the response of

the selected LO

or HI Dynamic

The Filter freq,

level, and Q are

adjusted by

dragging the

‘

target’ o

setting values

Tick the check box to switch

the filter out of the circuit

Filter Mode tab

Choose a notch, pass

or shelf filter

Filter Shaping

tab

Control panels

appear as you

add Filters

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 64 65

Comments to this Manuals

No comments

Klark Teknik DN9344E User Manual Page 20

Comments to this Manuals