Klark Teknik DN9344E User Manual download pdf (Page 28)

HELIX DN9340E/DN9344E Remote Control Software

User Guide

28 of 65

7.3.2 Ethernet connection – wireless option

The system set up for the wireless option Ethernet connection is via an Ethernet cable connected to the

network socket of the wireless access point and to either an Ethernet socket on one of the HELIX

DN9340E/DN9344E units (daisy chain), or an Ethernet switch or hub, depending on system

configuration. The system is then operated remotely from a tablet or laptop PC.

Note

If Solo Tracking input is required, the first HELIX must be a DN9340E.

7.3.3 Configuring the Network Devices

Before setting up the Ethernet system for operational purposes, you must first configure the system

devices, that is, the laptop/PC and HELIX DN9340E/DN9344E units to communicate with each other

using TCP/IP protocol. This is done by assigning them unique IP addresses on a shared system.

For a description of the Communications option in ELGAR’s System Configuration window and details on adding,

assigning, configuring and editing ports, saving configurations to a file etc., refer to the ELGAR Library

Manager User Guide. However, any HELIX RCS-specific information is detailed in Section 7.5.

 To configure an Ethernet device and assign a port to it

1 From the ELGAR menu, select Tools > Options.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 64 65

No comments

Klark Teknik DN9344E User Manual Page 28