Klark-teknik DN9344E User Manual download pdf (Page 27)

HELIX DN9340E/DN9344E Remote Control Software

User Guide

27 of 65

7.2.2 Connecting the HELIX DN9340E/DN9344E units to an Ethernet switch or hub

The diagram below shows each HELIX DN9340E/DN9344E unit directly connected to an Ethernet switch

or hub, which is then connected top a laptop/PC.

7.3 Ethernet Connection

For familiarisation purposes, a basic Ethernet connection may be made to a single unit by connecting

the Ethernet cable to either of the unit’s rear panel Ethernet sockets and to the network socket on the

laptop PC or wireless access point (wireless option).

For Ethernet connectivity, the HELIX DN9340E/DN9344E units must be operating V4.00 (or later) host

code. For details on setting up the IP address of the HELIX DN9340E/DN9344E units, please refer to

the HELIX DN9340E/DN9344E System Controller Operators Manual. For HELIX DN9340E/DN9344E unit

interconnection details, refer to Section 7.2.

7.3.1 Ethernet connection – standard

The standard system set up is an Ethernet connection via Ethernet cable connected to the network

socket of the laptop/PC and to either an Ethernet socket on one of the HELIX DN9340E/DN9344E units

(daisy chain), or an Ethernet switch or hub, depending on system configuration.

Note

If Solo Tracking input is required, the first HELIX must be a DN9340E.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 64 65

No comments

Klark-teknik DN9344E User Manual Page 27