Klark-teknik DN9344E User Manual download pdf (Page 14)

HELIX DN9340E/DN9344E Remote Control Software

User Guide

14 of 65

5 PROGRAMMING EQ

5.1 Graphic Equalisation

 To switch to the Graphic Equalisation view

 Click on the Graphic button of the Channel A or B Navigation Strip, as required. (If staying

on the same Channel, you may prefer to click on a Graphic tab).

The upper Graphic Mode tab is used to set the EQ type, bypass state, autogain etc. for the current

channel. The lower Graphic Shaping tab provides 31 fader controls for adjusting the gain of the 31

bands of the 1/3 octave equaliser; these are mirrored by fader controls along the frequency response

graph.

 To specify the EQ mode for the current channel

1 In the upper tab, open the EQ Type drop down

menu and select Proportional, Constant, or

Symmetrical Q. Type in or scroll to the required Q.

Select a Klark Teknik DN360 or DN27 emulation

curve from EQ Type drop down menu. The Q field

is disabled for the emulations.

Note

Refer to the DN9340/DN9344 Operators Manual for application notes on Equalisation modes

and Q.

Faders can

be adjusted

on the graph

or on the tab

Use the All Flat button

to reset all faders

Graphic Mode

tab

The black graph

shows combined

EQ. The red

graph shows the

response of the

selected fader

Tick the fader

check box to

switch it out

Graphic

Shaping tab

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 64 65

No comments

Klark-teknik DN9344E User Manual Page 14