Klark-teknik DN9344E User Manual download pdf (Page 15)

HELIX DN9340E/DN9344E Remote Control Software

User Guide

15 of 65

2 To apply autogain, tick the  AutoGain check box and type in (or scroll) the required value in

the field below.

3 Use the Unit Display  drop down menu to set the Graphic display mode that DN9340 units

should assume when taken out of slave operation; this only comes into effect if the slave is

a DN9430. The choice made here has no effect on your AddIn device display.

 To Bypass the graphic EQ on the current channel

 Tick the  Bypass check box in the upper tab.

 To adjust a fader level

To help fader selection at the graph, the frequency band and dB level is displayed as you hover

over a fader.

 Click and drag the fader on the graph or on the lower tab. The graph and tab faders are

linked so that they move simultaneously.

The overall frequency response (black line) updates as you adjust the fader. The individual response of

the fader is also shown (in red) while the fader is selected.

 To adjust a group of faders together

1 Click and drag the cursor diagonally over the group of

faders to enclose them in the selection box. The selected

faders are highlighted in red.

2 Click and drag any of the selected faders to move the

whole group up or down by the same dB while retaining

their relative values.

3 To deselect the group, click anywhere on the graph outside

the group.

The overall frequency response (black) updates as you adjust the

group. The individual response (red) is only shown for the fader that you drag. If required, the

response of the other faders can be checked by clicking on each one in turn.

 To reset all faders to zero

 Click on the All Flat button in the Global Graphic tab.

 To switch a fader out of the circuit

1 Tick the check box directly beneath the fader in the

lower tab.

The fader response is faded to grey on the graph (the

setting is retained for recall) and its contribution is

removed from the overall frequency response.

2 To switch the fader in again, clear the check box.

Fader In

Fader Out

Hint

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 64 65

No comments

Klark-teknik DN9344E User Manual Page 15