Klark Teknik DN9652 User Manual download pdf (Page 18)

Chapter 1: Getting Started

DN9650/DN9652 Network Bridge

4 Operator Manual

Configuring the unit for the first time

Important:

Before you use the unit for the first time, you must configure your computer

with the IP address and netmask to suit the range used by the DN965X.

Before you can use the DN965X as a network bridge, you must first configure it by

choosing the type of network module card(s) that are fitted in the unit and then setting

them up. Configuration involves connecting the DN965X to a computer running an

up-to-date web browser. To make sure your computer is compatible with the DN965X,

you will need to change its IP address and netmask. For more information on

configuration, see Chapter 5 "Configuring the DN965X" on page 17.

>> To connect the DN965X to a computer and then open its configuration

menu in the web browser

1 Connect an Ethernet cable to the CONTROL socket on the rear panel of the

DN965X and then to the Ethernet port of your computer.

Connecting a DN965X to a computer

2 Switch on the DN965X and your computer. (Note the default IP address of the

DN965X, which is displayed on its LCD screen during power up.)

3 To make sure your computer is compatible with the DN965X, we recommend that

you change the IP address and netmask of your computer to 192.168.2.1 and

255.255.0.0, respectively; for instructions, refer to your computer’s help and

support information.

4 Open your computer’s web browser.

Note: Make sure your web browser is up-to-date.

5 In the web browser’s address bar, type

in the following default IP address

(displayed on the unit’s LCD screen

during power up) and then press

ENTER:

“http://192.168.10.10”

Ethernet cable

Laptop PC/Mac

CONTROL

connector

Typical browser address bar

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 49 50

No comments

Klark Teknik DN9652 User Manual Page 18