Klark Teknik DY11 User Manual download pdf (Page 32)

Technical specification

20 Square ONE Splitter

Technical specification

Inputs 8 (mic/line)

Type

Maximum input level

Input impedance

Common mode rejection

ratio (CMRR)

Analogue, electronically balanced, female XLRs (Pin 2 hot)

+22dBu

5k ohms

-80dB at 1kHz (typical), unity gain (0dB)

-100dB at 1kHz (typical), maximum gain (+40dB)

Outputs 16 (rear panel)

Type

Operating level

Maximum level

Output impedance

Signal drive capacity

8 (front panel)

Type

Operating level

Maximum level

Output impedance

Signal drive capacity

Analogue, electronically balanced, male XLRs (Pin 2 hot)

0dB

+22dBu

<50 ohms

<600 ohms

Analogue, transformer isolated balanced, male XLRs (Pin 2 hot)

-6dB

+22dBu

<75 ohms

<600 ohms

Headphone

output

Type

Rating

Analogue, TRS jack socket

750mW (nominal 50 ohm load)

Terminations Audio

Power

Front panel connectors

Channel input: eight x AA series female XLRs (labelled “IN 1” to

“IN 8”)

Isolated output C: eight x AA series male XLRs (labelled “TX OUT 1”

to “TX OUT 8”)

Headphone output: one 1/4” TRS balanced jack socket

Rear panel connectors

Channel input: eight x AA series female XLRs (labelled “IN 1” to

“IN 8”)

Electronic output A: eight x AA series male XLRs (labelled “OUT A”)

Electronic output B: eight x AA series male XLRs (labelled “OUT B”)

3-pin IEC

Performance

Frequency response

±0.5dB (input to output), 20Hz to 20kHz

Distortion <0.02% @ 1kHz, 0dBu at unity gain

Dynamic range

Electronically balanced outputs: >122dB

Transformer isolated outputs: >140dB

Noise floor

Unity gain <-100dBu

Mic EIN @ +40dB gain <-128dBu

High pass

filter

Filter frequency

Filter slope

-3dB @ 30Hz

12dB per octave

Power

Requirements

Voltage

Frequency

Consumption

100VAC to 240VAC ±10%

50Hz to 60Hz

<35W

DOC02-SQ1SPLITTER_Square ONE Splitter_Op_IssC.pdf 32 27/04/2010 17:00:43

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 43 44

Comments to this Manuals

No comments

Klark Teknik DY11 User Manual Page 32

Comments to this Manuals